Plastica dos Fios Restorative Mask Step 3 – 1 Liter/33.8fl.oz


Out of stock


The Plastic of the Yarn Restorative Mask promotes the maximum hydration of the yarns reducing frizz and accentuating the smooth effect. Products are not available individually.


Amino acids: balance the structure of the yarns of aggressions caused by the excessive use of dryers and washers. Increases suppleness and elasticity, making hair softer and easier to comb.

Phytonutrients: Nourish and protect hair strands, helping to regenerate damaged and worn parts.

Try WASHER PLASTIC MASK RESTORING STEP 3 – 1 LITER/33.8fl.oz and check the results.



Materials Needed: Silicone gloves, dryer, plank, plastic tabs, thin comb, brush and plastic container.

1- Wash the hair with the Pre Treatment Shampoo, massaging until it forms foam. Wash twice in case of virgin hair, very resistant or very dirty. Leave on for 5 minutes and rinse thoroughly. Attention: do not rub the scalp.

2- Dry the hair in 80% with the dryer and help of the fingers.

3 – Separate the hair in 6 parts (a vertical line separating the hair in two rows – right and left – and 3 horizontal sessions – nape, middle and front from the ears). Hold each session in a bun with a loop.

4- Pour 20 to 40ml of the Thermal Seal into a container and put on the silicone gloves.

5- Begin applying a wick on the back of the neck with the aid of a brush. Apply two fingers of the root at the base of the wick and pull the product up to the tips with the comb. Make sure that the product is on all hair strands.

6- Repeat the procedure with the side wick.

7- With the dryer in the cold jet, dry the two wicks in 100%. It is important to dry two wicks at a time with the cold jet. This avoids the formation of smoke and prevents the product from evaporating without effect.

8- Repeat the procedure from 5 to 7 on the two middle hair strands, one at a time.

9- Finally, repeat the procedure from 5 to 7 on the two front wicks of the hair, drying the hair strands back. It is important that neither the dryer wind nor the wick with the product come into contact with the face.

10- Time to surf! In blond, damaged or chemical hair the temperature of the board should not exceed 200 ° C. In normal, virgin or temperature resistant hair it should be at 230 ° C.

11- Divide the hair back into parts using clips. Separate a thin, linear wick and draw the length (without the tips) of the wick 10 times (board at 200 ° C) or 7 times (board at 230 ° C).

12- Practice the tips (without the length) of the hair up to 4 times (plank at 200 ° C) or 2 times (board at 230 ° C). This way you avoid the artificial smooth effect on the tips.

13-Repeat this process (step 11 and 12) through all strands of hair. The flat iron in relation to the leather leaves the hair strands smoother naturally from the root.

14- After plating all the wicks, rinse well the hair.

15- Apply the Restorative Mask on the threads by gently massaging the wicks. Leave on for 5 minutes and rinse again.

16- Dry the hair with the dryer.

Note: In the case of relaxed or softened hair, apply the plastic thermal sealing of the threads after the chemical process. In case of dyeing or toning, apply the Plastic Thermal Wire Fence two days before or after dyeing, to better fix the color pigments in the threads.


We recommend that you use this treatment with the help of a professional.


Tip: For best results, use the rest of the Wire Yarn line together.



Stronger, repaired hair with incredible shine!